contact print

This one is from the summer of 2008.

I was walking in down town Nicosia with my Speed Graphic and some film holders loaded with x-ray film (cut down from 15x30cm sheets) looking for something interesting to shoot.

Enter a group of teenagers with their skateboards in front of the neoclassical Faneromeni school.

It was late afternoon, so light was getting low. Asked if I could take some pictures of them, and quickly setup the camera pre-focusing on the spot where they were doing their jumps.

For some reason I decided to try stand development on these negatives. First and last time I did that with the Jobo 2509n reel and the 2521 tank. This negative has about 4mm on the long edge (top of the picture) significantly overdeveloped.

Didn’t find the processing notes, but at the time I was using mostly Rodinal in dilutions between 1/100 and 1/300. Time must have been between 10 and 20 minutes. The negative is slightly under developed, which makes it a bit thin.

The picture here is a scan (cropped the top out) from a contact print I did a couple days ago on Ilford MG Warmtone RC Pearl.

Skaters - on x-ray film


Saying goodbye to 2015 with the first successful contact print from the new 18x24cm pinhole camera that I built.

150mm focal length
0.5mm pinhole
8sec. exposure

Agfa CP G+ (x-ray film) at 100asa.
Tray developed by inspection in Ilford MG 1+100 at 22C for 7min.

Scan from contact print on Ilford MG Warmtone RC Pearl.

The Olive Tree The Sun And The Bike

%d bloggers like this: